Yard-man YM26CO User Manual download pdf (Page 13)

5. Check the indexing teeth on the inner reel and outer

spool for wear. If necessary, remove burrs or replace

the reel and spool. See Figure 19.

SECTION 7: MAINTENANCE AND REPAIR INSTRUCTIONS

NOTE: SplitLine™ can only be used with the inner reel

containing slotted holes. Single line can be used

on either type of inner reel. Use Figure 20 to

identify the inner reel you have.

Indexing Teeth

NOTE: Always use the correct line length when installing

trimming line on the unit. The line may not

release properly if the line is too long.

Single Line Installation

Go To Step 8 for SplitLine™ Installation

6. Cut approximately 25 feet (7.6 m) of new trimming

line, then loop it into two equal lengths. Insert each

end of the line through one of the two holes in the

inner reel. Pull the line through the inner reel so that

the loop is as small as possible. See Figure 21.

Slotted Holes

For Use with SplitLine™

or Single Line

For Use with

Single Line ONLY

7. Wind the lines in tight even layers onto the reel. See

Figure 22. Wind the line in the direction indicated on

the inner reel. Place your index finger between the

two lines to stop the lines from overlapping. Do not

overlap the ends of the line. Proceed to step 11.

SplitLine™ Installation

8. Cut approximately 12 feet (3.65 m) of new trimming

line. Insert one end of the line through one of the two

holes in the inner reel. Pull the line through the inner

reel until only about 4 inches is left out. See Figure 23.

9. Insert the end of the line into the open hole in the

inner reel and pull the line tight to make the loop as

small as possible. See Figure 23.

Loop

10. Before winding, split the line back about 6 inches.

11. Wind the line in tight even layers in the direction

indicated on the inner reel.

NOTE: Failure to wind the line in the direction indicated will

cause the cutting attachment to operate

incorrectly.

12. Insert the ends of the line into the two holding slots.

See Figure 24.

13. Insert the ends of the line through the eyelets in the

outer spool and place inner reel with spring inside

the outer spool. See Figure 25. Push the inner reel

and outer spool together. While holding the inner reel

and outer spool, grasp the ends and pull firmly to

release the line from the holding slots in the reel.

Figure 19

Figure 21

Figure 20

Figure 23

Figure 22

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

Comments to this Manuals

No comments

Yard-man YM26CO User Manual Page 13

Comments to this Manuals

Related products and manuals for Gardening equipment Yard-man YM26CO