Installation of operating arms and splitting cross
Operating arms
1. Fit the operating arm and insert the tube in the cross coupling recession.
TIP: Lubricate the sheet couplings with grease from above and from below!
2. Put the holding pin through before the cross coupling.
3. Set the clamping plates to the corresponding wood diameter.
4. Secure the holding pin with a cotter at the
bottom (included in the supply).
Splitting cross installation
1. Screw the fixation bolt half to the splitting cross.
2. Screw the nut (included in the supply) to
the inner side.
3. Apply the splitting cross and turn the fixation bolt in the knife recession until the
nut is tightened.
Mazání
tukem
3
4
1
2
3
1
2
2a
Comments to this Manuals