Yard-man YM300 User Manual download pdf (Page 7)

SECTION 3: ASSEMBLY INSTRUCTIONS

Bolt

Washer

Wing Nut

Tighten

Shaft Grip

D-Handle

Installing and Adjusting the D-handle

1. Push the D-handle down onto the shaft housing so

that the handle slants towards the shaft grip. Make

sure the squared bolt hole in the handle is to the

right. See Figure 1.

2. Insert the shoulder bolt into the squared hole in the

handle and push through. On the left side of the

handle, place the washer on the bolt, then screw the

wing nut onto the bolt. Do not tighten until you make

the handle adjustment.

3. Rotate the D-handle until the grip is above the top of

the shaft housing. Place it a minimum of 6 inches

(15.24 cm) from the end of the shaft grip.

Minimum 6 inches

(15.24 cm)

Shaft Housing

4. While holding the unit in the operating position,

arrange the D-handle in the location that provides

you the best grip. See Figure 2.

5. Tighten the wing nut until the D-handle is secure.

Figure 1

Figure 2

Installing the Cutting Attachment Shield

Use the following instructions if the cutting attachment

shield on your unit is not installed.

WARNING: To prevent serious personal

injury, never operate the trimmer without

the cutting attachment shield in place.

1. Place the cutting attachment shield onto the shaft

housing. Be sure the guard mounting bracket slides

into the slot on the edge of the cutting shield. Rotate

the shield into place, counterclockwise. The holes in

the guard mounting bracket and cutting attachment

shield will line up. See Figure 3.

Figure 5

2. From inside the cutting attachment shield, push the square

bolt through the hole until the threaded end protrudes

through the guard mounting bracket. See Figure 4.

Guard

Mounting

Bracket

Shaft Housing

Square Bolt

Cutting Attachment

Shield

3. Put the washer on the bolt, then screw the wing nut

onto the bolt and tighten. Figure 5 shows the

installation process from underneath the unit.

Guard

Mounting

Bracket

Wing Nut

Cutting Attachment and Shield: Underside View

Cutting

Attachment

Shield

Wing Nut

Washer

Square Bolt

Washer

Hole

Figure 3

Figure 4

1 2 3 4 5 6 7 8 9 10 11 12 ... 63 64

Comments to this Manuals

No comments

Yard-man YM300 User Manual Page 7

Comments to this Manuals

Related products and manuals for Gardening equipment Yard-man YM300